PES™
Original Power Box
Product Information
and Instruction Manual
Welcome to the P.E.S. family. We hope that you enjoy your new P.E.S. product fully. To help you achieve that goal, we recommend that you read this manual. If you still have any questions after reading this manual, please do not hesitate to contact us.
Toll Free (US only): (800) 339-6953
Phone: (702) 474-2991
Fax: (702) 474-4088
Websites:
http://www.peselectro.com
http://www.danteamore.com
http://www.thefetishboutique.com
Email:
pesquestions@peselectro.com
Follow Us on Twitter:
http://twttter.com/peselectro
Like Us on Facebook:
http://www.facebook.com/PES.Studio
Enjoy,
The Staff of P.E.S.
Includes:
To property experience the effects of EROTIC ELECTRO STIMULATION, you need to leant how to property operate your PES POWER BOX. A little reading, experimentation, & practice are all it takes to have a pleasurable experience. Here are the steps to follow each time reo use your PES POWER BOX:
1. Start by making sure the ON/OFF switch on the left side of your PES POWER BOX is in the OFF/DOWN position.
2. Attach the tow LOW PROFILE LEAD(S) to the ELECTRODE(S) you are planning to use.
(NOTE: HOW TO APPLY LOW PROFILE LEAD(S) IS ON THE BACK OF THE MANUAL.)
3. Insert the 3.5 MM PLUG on the end of your LOW PROFILE LEAD(S) into the jack for either CHANNEL A or B (located on the top edge of your PES POWER BOX).
4. For maximum power, use the Included 12 VOLT 1.5 AMP A/C ADAPTER to power your PES POWER BOX. The input jack for the A/C ADAPTER is on the left side of the POWER BOX below the ON/OFF switch.
(NOTE: A 9V BATTERY CAN BE USED INSTEAD OF THE INCLUDED A/C ADAPTER.)
5. Check the controls on the face of the PES POWER BOX. There are four knobs on the face of the unit: COARSE (upper left), FINE (upper right), PULSE (bottom left) & FREQUENCY (bottom right).
6. All four knobs have numbers from 1 to 10 around them. Make sure the COARSE & FINE, both of which control the power, are set to 1. Set the PULSE & FREQUENCY knobs to 10.
7. Lubricate the ELECTRODE(S) & the area of the body to which you will be applying them. Apply the ELECTRODE(S) to your body according to the instructions for each ELECTRODE.
(NOTE: LUBRICATION MAY VARY, PLEASE REFER TO THE ELECTRODE INSTRUCTIONS.)
8. Once you have applied your chosen ELECTRODE(S) & chocked the power settings on your POWER BOX, turn on your POWER BOX by switching the ON/OFF switch to the ON/OFF position. The LED indicators on the top face of the PES POWER BOX will light up.
IMPORTANT SAFETY NOTE: ALWAYS REMEMBER TO LOWER THE POWER LEVEL & TURN OFF THE PES POWER BOX EACH TIME YOU ADJUST, REMOVE, OR INSERT ANY ELECTRODE.
9. With the switch In the ON/OFF position, slowly turn the COARSE clockwise to a comfortable level.
(NOTE: Some users may find they turn the knob to 10. Do not panic, that isn't strange.)
10. Next, you can add more power by slowly turning the FINE clockwise. This increases the power in smaller increments in order to achieve the maximum amount of stimulation possible.
(NOTE: Your tolerance will increase with prolonged use, thereby requiring adjustment to higher levels.)
When you have found COARSE & FINE you like best, move on to the FREQUENCY & PULSE knobs.
11. The FREQUENCY is the length of the electrical wave & specifically affects the erotic nerve bundles you are stimulating. With the FREQUENCY knob set at 10, you will feel a high level of tingling. As you lower the FREQUENCY, the sensation will change to a deeper, rumbling throb.
Ono way to understand this affect is to think of it as the treble / bass controls on your stereo. You will most likely find the HIGHER frequency settings more pleasurable: SMOOTHER; & the LOWER settings less pleasing; SHARPER.
12. With the PULSE set at 10, a constant flow of ELECTRIC ELECTRO STIMULATION can be feltthrough the conductive surface(s) of the ELECTRODE(S). As you lower the setting, you will notice a delay in the sensation, as Indicated by the blinking LED lights. The lower the PULSE is set, the longer the delay. When you have found your optimal settings with the other control knobs, you can play with the effects by adjusting the PULSE.
Physiologically, the mind/body will tend to find а HIGHER PULSE setting more PLEASURABLE and a LOWER PULSE setting more BITING.
13. On the right side of your PES POWER BOX is a DIAL. This is the FINE FREQUENCY DIAL.
Once all the other control knobs have been adjusted to the optimal settings for you, this DIAL can be used to FINE-TUNE the FREQUENCY of the stimulation by simply rotating the DIAL. This DIAL provides a deeper sensual stimulation.
In simpler terms, it can make the sensations feel rougher or smoother when rotated.
The CHANNEL A & В POWER INTERRUPTS can be used to temporarily cut off the power to your ELECTRODE(S). As long as the button is pressed, no power is flowing to that channel.
This can be used for play or safety purposes.
For safety reasons, the PES POWER BOX & its accompanying ELECTRODES are to be used below the waist only. CHANNEL A or B can be used alone or in combination for any ELECTRODE or ELECTRODES (see under CONFIGURATION in the GLOSSARY). Also, for safety reasons, we recommend that only one person be attached to the PES POWER BOX at any one time.
Input Jacks for Channels A& В
LED Indicators / Fine Power Knob
Coarse Power Knob / Fine Frequency Dial
А/С Adapter Jack / Pulse Knob / Frequency Knob
On/Off Switch / Channel А & В Power Interrupts
This is the use of LOW FREQUENCY ELECTRICAL IMPULSES from a GENERATING SOURCE delivered to an ELECTRODE or ELECTRODES to enhance an individual's natural sexual response. It is also referred to as ESTIM, ELECTRO SEX, ELECTRO STIM, ELECTRICAL STIMULATION, or EES.
This is the POWER SOURCE for the EROTIC ELECTRO STIMULATION also known as a POWER BOX, e.g. the ORIGINAL PES POWER BOX it controls the LOW FREQUENCY ELECTRICAL IMPULSES being delivered to the body via the ELECTRODE(S). Some use MADE-FOR-PLAY BOXES, TENS UNITS, or other NMES-STYLE UNITS.
This is the device through which the EROTIC ELECTRO STIMULATION is delivered to the body. They are typically comprised of CONDUCTIVE & NON-CONDUCTIVE areas out of various CONDUCTIVE MATERIALS. These come in SINGLE-, DOUBLE-, TRIPLE-, or QUADRUPLE-POLE versions.
ELECTRODES are the COCK RINGS, ANAL PLUGS, SELF-ADHESIVE PADS, DILDOS, or other forms containing the CONDUCTIVE SURFACES that are applied to the erogenous zones.
A SINGLE ELECTRODE requires a second ELECTRODE be used in circuit with it in order to function.
This is a combination of what ELECTRODES are being used & their placement on the body's erogenous zones for maximum efficacy.
This is the end of your LEAD that attaches to the ELECTRODE(S). There are two of each pair of LEADS. Both of them need to be connected in order to create a complete circuit.
The point on the ELECTRODE where the LEADS are attached. There are either one, two, three, or four of those on an ELECTRODE, depending on whether it is SINGLE-, DOUBLE-, TRIPLE-, or QUADRUPLE-POLE.
An important part of successful EROTIC ELECTRO STIMULATION is CONTACT. In regards to all ELECTRODES, whenever a space is created between the ELECTRODE & the contact area (skin or muscle tissue), electricity will arc over that space. This creates a slight "zapping" sensation that can be uncomfortable, & very undesirable for some users.
Occasionally, you will read cautions about how to prevent 'NON SPOTS'. These unpleasant sensations are caused by too little lubrication, unshaven pubic hair, contact with metal (such as jewelry), or by not achieving full contact between the electrode & the skin.
'NOT SPOTS' may not occur under all of these conditions for everyone. If you experience a 'NOT SPOT' road your directions pertaining to the ELECTRODE in use, & the problem should easily be made clear, & solved with one or two simple corrections in use.
This is the abbreviation for 'HANDS-FREE ORGASM', which Is an orgasm where no physical contact from your hands or someone else’s hands is needed with the genitals in order to achieve climax. With ELECTRO STIMULATION, it is an orgasm achieved by ELECTRODE placement combined with the settings of your generating source & no manual or oral manipulation of the genitals.
More information can found on the P.E.S. website:
HTTPS://WWW.PESELECTRO.COM
the 'INFORMATION' links at the bottom of the HOME PAGE.
Specifically under the
'PRODUCT SAFETY & INFORMATION LINKS'.
The ORIGINAL PES POWER BOX shown above with the BASIC CORONA "COCKHEAD" STIMULATOR in circuit with the ANAL TUBULAR on CHANNEL A & a single pole ELECTRO-FLEX™ PENILE RING on the green wire and plugged into CHANNEL B for a 3-ELECTRODE CONFIGURATION. ELECTRODES sold separately.
The safety at our customers has always been of primary concern to PARADISE ELECTRO STIMMULATIONS, INC. In that regard, here are the primary safety considerations for users of the ORIGINAL PES POWER BOX with its various ELECTRODES.
Do not use any solvents to clean the ORIGINAL PES POWER BOX. Using a damp cloth or towel will suffice.
You may clean your PES ELECTRODE(S) with a solution of 10% household bleach & 90% water a few drops of mild dishwashing liquid added. Do not soak. For additional disinfection, use a product like SWISS NAVY® TOY & BODY CLEANER after washing with soap & water. DO NOT use isopropyl Alcohol on any of the clear Acrylic vaginal or anal products.
PES, INC recommends the use of a proper lubricant with all PES ELECTRODES. A good lubricant not only lubricates, but also can decrease the possibility of hot spots. PES ELECTROLUBE not only lubricates, but also has conductive properties & can increase the strength of the EROTIC ELECTRO STIMULATION by as much as 40% by lowering the skin's resistance.
You can also adjust & balance the EROTIC ELECTRO STIMULATION by increasing the conductivity of a particular electrode or an area of that electrode by simply applying more PES ELECTRODES to the skin beneath For urethral devices, such as the SPARKLER, BIG BOY SPARKLER, BEEP THREAT SLIM JIM, BEEP THRGAT BIG JIM., & the CORONA STHIMULATOR WITH URETHRAL AMPILFILER, we strongly recommend the use of STERILE LUBRICATING JELLY. Water-based lubricants, such as STERILE LUBRICATE JELLY, can be used as an alternative if you do not have a conducive lubricant, such as PES ELECTROLUBE.
NOTE: DO NOT use any silicone-based lubricants. Silicone is an insulator & thus, reduces the conductivity of the ELECTRODE. With ELECTRO-FLEX™ PRODUCTS silicone-based lubricants may cause permanent damage to the ELECTRODE(S). Glycerin-based or mineral oil-based lubricants should also be avoided because they tend to dry out rapidly & become sticky & can thus decrease the sensations of the EROTIC ELECTRO STIMULATION.
GVERSEAS 220 VOLT A/C ADAPTER (supplied by PES, INC)
The ORIGINAL PES POWER BOX is manufactured to operate on a standardized U.S. electrical current. It can be powered with a 9 VOLT BATTERY but an A/C ADAPTER gives greater and more consistent power. In order for Overseas Customers to operate the ORIGINAL PES POWER BOX properly. PES has invested in an A/C ADAPTER that will work universally. This 12 VOLT 1.5 ADAPTER is rated for input of 100 volts to 240 volts 50/60Hz 4Amp it is center pole positive and works in the U.S. as well as overseas. It comes with blades for plugging into wall outlets in North America or the EU, so customers outside of those areas will need to purchase the correct blade adapter for the wall outlets in their country (not supplied by PES).
PES, INC. is not responsible for misuse of the adapter and voltage guidelines set forth in this notice. The PES supplied A/C ADAPTER is available for purchase on the chance a replacement is needed. In the event these guidelines are violated, al warranties on the ORIGINAL PES POWER BOX will be null and void.
THESE PRODUCTS ARE FOR ADULT NOVELTY USE ONLY, THERE ARE NO IMPLIED MEDICAL CLAIMS WARRANTED OR IMPLIED BY THE OF THIS PRODUCT.
PARADISE ELECTRO STIMMULATIONS, INC will not be liable for any damage, mishap, or injury resulting from the use of PES PRODUCTS. By using our products, you acknowledge that you have read the safety information contained herein, and the directions for use of these devices, and you accept responsibility and liability for your actions.
Due to the personal nature of the products and for hygienic reasons, there are no returns or refunds on any of the ELECTRODES.
We offer a 30-DAY WARRANTY on all products against manufacture defect. In the event of a defect, you must contact us by email: PESQUESTLONS@PESELECTRO.COM or phone: (702) 474-2992 (or (800) ЗЗ9-6953-US only) for a return manufacturer authorization number. Any product received without an RMA# included on the mailing label will be returned unopened. Repair/replacement is available beyond the warranty period but there may be charges.
NOTE: ANY PRODUCT SHIPPED / RETURNED FOR EVALUATION MUST BE CLEANED & DISINFECTED THOROUGHLY BEFORE BEING SENT IN TO US. THANK YOU FOR YOUR CONSIDERATION.
Within the FIRST 30-DAYS the ORIGINAL PES POWER BOX, only, may be returned for a full refund minus a 15% restocking fee. You must return the POWER BOX, AC ADAPTER, & LEADS (2 pairs of Low Profile Leads). This refund applies only to the ORIGINAL PES POWER BOX.
NO RETURNS, REFUNDS, OR EXCHANGLES WILL BE ACCEPTED ON PES ELECTRODES OR ACCESSORIES.
NOTE: PES, INC products are specifically designed and engineered to work exclusively with PES, INC technology / products to optimize their function end safety. USE OF PES ELECTRODES, POWER BOXES, OR LEADS WITH POWER SUPPLIES, ELECTRODES, OR LEADS OTHER THAN PES ELECTRODES, POWER BOXES, OR LEADS MAY DAMAGE THESE DEVICES, CAUSE INJURY, & WILL VOID ALL WARRANTIES, EXPRESSED OR IMPLIED.
COPYRIGHT© 2002-2016
THE CONTENTS OF THIS MANUAL, INCLUDING ALL PICTURES & TEXT ARE COPYRIGHTED, & THE SOLE PROPERTY OF PARADISE ELECTRO STIMULATIONS, INC, & MAY NOT BE REPRODUCED WITHOUT THE WRITTEN PERMISSION OF PARADISE ELECTRO STIMULATIONS, INC.
Proper application/removal of your P.E.S. Low Profile leads:
Note: DO NOT attempt to apply the LOW PROFILE CONNECTION by force or to remove the LOW PROFILE LEADS by pulling on the load wire. This will load to failure of the LOW PROFILE CONNECTION.
Closed /
Opened
3.5mm Plug (0.14 Inches)
Low Profile Connectors
1.22m (48 inches) Cable Length